RDG603A11 - Issue 8 - Shire 14 70, 85 & 130 WB Owners
Manual Page 29 of 50
2.
Air Filter Check & Change
CAUTION:
WEAR DISPOSABLE GLOVES AND BEWARE OF HOT ENGINE BLOCK. REMOVE
THE IGNITION KEY BEFORE WORKING IN ENGINE COMPARTMENT.
•
Release the two spring clips, pull off the end cover to reveal the filter element. The
element simply pulls out. Note: the Shire 90 has an inner safety element fitted.
•
The air filter element is constructed from pleated paper; inspect it closely for dust
or
dirt. The air filter cannot be cleaned and must be replaced when dirty. The engine
requires clean unrestricted air to run efficiently, failure to
maintain the air filter
could
result in smoke, increased fuel consumption and ultimately engine damage.
•
To fit the new element, slide the open end of the filter element into the main body;
gently push the element home until fully seated. Refit the end cover.
3.
Gearbox Oil Change
CAUTION:
WEAR DISPOSABLE GLOVES AND BEWARE OF HOT OIL AND GEARBOX CASING.
REMOVE THE IGNITION KEY, BEFORE WORKING IN ENGINE COMPARTMENT
.
•
Change the gearbox oil while it is still hot. (Please refer to PRM gearbox manual for
more information).
•
Remove the plug from the gearbox drain pump; this is the smaller of the two pumps
(6mm Allen key).
•
Pump contents in a suitable container (not less than 3 litres).
•
Refill the gearbox with oil to the upper mark on the dipstick. Screw dipstick in fully to
establish level. The gearbox uses the same grade of oil as the engine.
•
Do not overfill gearbox as this can damage the internal components.
