23
TROUBLESHOOTING
Saw Will Not Start
Check power cord and receptacle.
Motor Overheating
If motor overheats allow to cool for 2 to 3 hours, push reset
button with power disconnected, hookup power cord and resume
cutting by pulling the power switch to the ON position. All motors
have automatic thermal protection and will shut off if overheated.
Do not use long (25"+) drop cords.
Vise carriage can not be moved by hand when clutch is disengaged
Adjust clutch by loosening the slotted locking screw, turn 2 allen set screws 1/2 turn clockwise, re-
tighten slotted locking screw. Check to see if carriage is disengaged from screw feed by placing clutch
lever in 12 o'clock
position and moving carriage by hand over rails.
Vise carriage does not move automatically when clutch is engaged
Clutch block thread may be stripped or worn. Remove and replace bronze clutch block.
Blade will not cut properly
Check for damage or glazed diamond cutting kerf (segments). Replace damaged blades or resharpen
dull segmented blades.
Motor reset button
HP18-24 SLAB SAW
TROUBLESHOOTING
