19
Cylindrical grinding and installation of blade reel cylinder
Cylindrically grind the blade reel cylinder when it is worn away and has become conical.
(Ask the dealer you purchased the machine from for cylindrical grinding.)
[IMPORTANT] Installation of blade reel cylinder
6-4
6-5
Attaching/detaching the small cover
Remove the lapping bolt and the gear retainer collar in this order, and then remove the
left small cover.
Attach the left small cover, and then attach the gear retainer collar and lapping bolt in
this order. (Attach the left small cover so that the reel cutter shaft will be at the center
of the oil seal of the left small cover.)
6-6
reel gear securing nut
20 tooth reel gear
Non Groomer
2 SPCC washer 1635
16 Left hand thread nut 3P1.5
Left small cover
Lapping bolt
Gear retainer collar
Torque wrench
Groomer Model
1) Replace the bearings and reel shaft seals on both sides of the blade reel cylinder.
Use the bearing 30204JRP6 that has the smallest error.
2) Sufficiently apply grease (EXCELITE EPNO2) to the bearing and seal. (Apply
grease to the bearing while turning the roller.)
3) Method to fasten nut after installing the blade reel cylinder
[IMPORTANT] Tighten the nut until the length of the spring reaches 11.5 mm, and lock
the nut. A certain preload will be applied by the spring pressure. The rotational torque
of the blade reel cylinder should be 0.8~1.0N m(8~10kgf cm). If it is not, check the
bearing and seal.
0.3
Center of cam bush
Cam adjustment
Center of cutter pin
The bottom blade rises
The bottom blade lowers
10 disk spring H
