15
Groomer clutch lever
The lever is at the top of the groomer gear case on the outside of the right frame.
There are three changeover positions - "Normal rotation" (in the same direction as the
rotating direction of the blade reel cylinder), "Rotation stop," and "Reverse rotation" (in
the direction opposite to the direction of rotation of the blade reel cylinder). Change the
positions according to the type of work.
Adjustment of handle height
Move the securing bolt up and down in the slot of the handle guide, which is securing
the handle to the frame, in order to adjust the height of the handle according to the
operator's working position.
Brake lever
The lever is in the right-side grip section of the handle. Grip the lever, and the internal
expanding brake set in the second shaft section will operate.
The strength can be adjusted by the screw.
Do not park the machine on the slope.
5-4
Normal rotation
Reverse rotation
Rotation stop
Throttle lever
The throttle lever is on the left side of the handle. The lever controls
the engine speed. The speed of rotation is 1,400 - 3,400 rpm.
Operate at about 3,000 rpm.
[IMPORTANT] Adjustment of engine clutch
When reinstalling the engine
Adjust the clearance between the engine clutch and clutch facing so that it will be
approx. 0.5 to 1 mm when the travelling clutch is engaged. For adjustment, loosen the
four bolts that are securing the engine, and insert a thickness gauge (attached) into the
front and rear. Make adjustment so that the gap will be parallel, and then fasten the
bolts.
When adjusting the clutch wire
Make adjustment so that the operation distance of the clutch plate between the clutch
engagment and disengagement will be 0.8-1 mm.
5-5
5-6
WARNING
5-7
5-8
Engine clutch
Clutch facing
Clutch wire adjusting nut
1.0~2.0mm
Operation distance
Clearance
0.5~1.0mm
Releasing stopper lever
adjusting nut
