Before you can adjust the groomer you will need to make sure that the height of cut is set
correctly.
With the height of cut already set, fit the
setting bar to the machine as shown so
that the underside of the head of the
height of cut adjusting screw is sitting on
the cutting surface of the bottom blade
and that ends of the setting bar are
resting up against the rear and front
rollers.
With the groomer height already set
on the setting bar as previously
shown, check the distance between
the tips of the groomer blades and
the setting bar adjusting screw as
shown.
In this photograph the groomer is
set too high as there is a gap
between the tip of the blade and
the setting screw.
To adjuster the groomer height you will
firstly need to slacken the adjustment
locking nuts as shown.
Once they are loose, nip them up finger
tight in order to remove excess play but
to still allow the adjustment to take
place.
Repeat this on both sides of the
machine.