Baroness LM285, Owner'S Operating Manual, Page: 61 / 65

Immediately after replacement, drive to break
in the brakes if the effectiveness of the brakes
is low.
While driving, lightly operate the brakes to
break in the contact areas.
Adjusting the Neutral Position of the
Piston Pump
Caution
Make sure not to touch rotating tires.
If the machine moves forward or backward while
the traveling pedals are released, they are not
set to the neutral position.
Follow the steps below to make adjustments.
Stop the engine.
Place the jacks beneath the jack-up points,
and then lift the machine off the ground.
Use stable jack stands, and raise the
machine until the tires lift off the ground.
（
(See "Jack-up Points" (Page 5-5) .)
Start the engine, and rev it up to the
maximum rpm.
Adjust the neutral position.
If the front tires rotate forward, loosen the
lock nuts, then turn the front wheel rod to
shorten it.
If the front tires rotate in reverse, loosen
the lock nuts, then turn the front wheel rod
to extend it.
1
2 3
4
5
5
hsn2jo-001
Adjusting the Neutral Position of the Piston Pump_001
1 Rear wheel rod
2 Front wheel pump
3 Rear wheel pump
4 Front wheel rod
5 Lock nut
Find the position where the front wheels
stop, and then tighten the lock nuts.
1.
2.
3.
4.
[1]
[2]
5.
Follow the same steps to adjust the rear
wheels.
Change of Constant Velocity Joint
Caution
Do not use any other grease than the grease
for the NTN constant velocity joint.
If grease leaks from the joint and attaching
portion or boot band attaching portion, replace
the boot and O-ring etc.
You cannot reuse the boot band. Be sure to
replace it with a new one.
1
2
4
3
85kq7c-001
Change of Constant Velocity Joint_001
1 Hydraulic pump
2 Boot band
3 Boot
4 Engine
Change of Fuse
Fuse Box
The fuse box includes spare fuses and tools.
1
pkm25s-001
Fuse Box_001
1 Fuse box
6.
Ma
intena
nce
LM285
Maintenance
Page 5-13
Maintenance (Main Body)