Baroness LM180E, Owner'S Operating Manual

Page: 41 / 72

1 Frame
Raise all mower units.
Set the change lever to the "Neutral"
position.
Remove the wheel stoppers.
Release the parking brake.
Warning
While towing, always keep your foot on the
brake pedal and depress the brake pedal at
any time to stop.
Tow the machine slowly.
Cutting Work
Cutting Operation
Caution
Cutting work must be performed at an
appropriate speed for the site and location.
When cutting bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
Lower all the mower units.
Start the engine.
"Procedure to Start Engine" (Page 4-13)
Move the throttle lever to the "High speed"
position.
Shift the change lever in arbitrary position.
Slowly pull the reel rotation lever in the same
way as clutch-slipping to rotate the reel
cutters (cutting cylinders) of the left and right
mower units.
Slowly pull the traveling clutch lever in the
same way as clutch-slipping to move the
machine forward while rotating the reel cutter
(cutting cylinder) of the rear mower unit.
Shift the traveling clutch lever to the "ON"
position, and then start the operation.
Transporting
Transporting Procedure
When loading the machine into a trailer or a
truck to transport it, drive the machine in
reverse. When unloading, drive the machine
forward.
5.
6.
7.
8.
9.
1.
2.
3.
4.
5.
6.
7.
Storage
Before Long-Term Storage
Cleaning
Remove dirt, grass clippings, oil stains etc.
completely from the main vehicle and
engine.
Replacing oil
Inspect and replace the engine oil and
element.
Greasing and lubricating
Supply oil and apply grease to appropriate
parts.
Fuel
Remove the fuel from the fuel tank.
Tire pneumatic pressure
Set the tire air pressure slightly higher
than normal, and then place the machine
on a board to avoid humidity.
Mower units
When storing this machine, lower all the
mower units unless a positive mechanical
lock is provided.
Storage location
Cover the machine and store it in a dry
place where it will not be exposed to rain.
1.
･
2.
･
3.
･
4.
･
5.
･
6.
･
7.
･
Handling Instructions
LM180E
Handling Instructions
Page 4-21
Cutting Work