Important
Adjust the position so that the vertical blade
can make contact with the small screw for
groomer setup.
1
4
3
2
A
2qrq2r-002
Adjustment of Groomer_004
1
Vertical blade
2
Small screw for groomer setup
3
Cutting height gauge
4
Front roller
A
Groomer height
Adjust the groomer height with the groomer
adjustment nut.
Follow the same steps to adjust the groomer
height on the opposite side.
Bring the cutting height gauge into contact
with the front and rear rollers at the left and
right ends of the mower unit again, and
check that the groomer is at the desired
height.
Adjustment of Groomer Spring
Note:
Depending on the specifications, this function
may not be available.
Adjust the height of groomer.
Loosen the pipe with adjustment screw and
adjust it so that the length of the groomer
spring is approximately 45.0 mm (1.77 in).
6.
7.
8.
1.
2.
2
1
A
LH66_SP0_131
Adjustment of Groomer Spring_001
1
Pipe with adjustment screw
2
Groomer spring
A
45.0 mm (1.77 in)
Adjustment of CR Brush
Adjustment of CR Brush (CR Brush Only
Installation)
Note:
Depending on the specifications, this function
may not be available.
Important
Do not place the brush in contact with the rear
roller too tightly.
It will cause belt slip and break.
Important
The rotating CR brush prevents grass
clippings, etc., from attaching to the rear roller.
Loosen the left and right bolts and nuts
used to install the CR brush.
Adjust the CR brush so that there is a
clearance of 0 to 1.0 mm (0 to 0.039 in)
between it and the rear roller, and then
firmly tighten the loosened bolts and nuts.
3
4
1
1
2
zp6tso-004
Adjustment of CR Brush (CR Brush Only Installation)_001
1.
2.
LH62
・
LH66
Handling Instructions
Page 4-12
Adjustment before Work
