-24-
Lock nut
(left-hand thread)
Lock nut
(right-hand thread)
Lock shaft
Groove
Groove
Traveling lever
Neutral stopper
M10 right-/left-hand thread rods
16-1. Adjustment of neutral position of piston pump
Loosen the mounting bolts of the neutral lever mounting bases for the pump on
both sides to keep the bolts loose.
Return the side brake lever to unlock the traveling lever.
Start the engine, and move the neutral lever mounting bases for the pump by
using a stick, etc. to determine the neutral position.
The engine is rotating. Be careful of the pulley, belt, sprocket (crawler), etc. during
operation.
When the neutral positions of both bases are determined, stop the engine and
tighten the mounting bolts.
Start the engine again to check that the sprocket (crawler) will not rotate.
Pump
Mounting bolt
Left neutral lever
mounting base for pump
Right neutral lever
mounting base for pump
16-2. Adjustment of neutral position of traveling lever
Loosen all the lock nuts of the M10 right-/left-hand thread rods.
Turn the two rods at right and left to adjust the length so that the lock shaft of the
traveling lever will be set in the neutral stopper groove when the side brake is
pulled.
Tighten all the lock nuts of the rods and check that the traveling lever is locked
completely when the side brake lever is pulled and that the traveling lever is
unlocked quickly when the side brake lever is returned.
CAUTION
2
1
3
4
1
2
3
