Barnett Engineering ProTalk Cv3, Installation & Operation Manual, Page: 13 / 50

PROGRAMMING PAGE 9
Programming With A Handset
The B1277 is capable of recording voice messages and limited
programming using a TouchTone telephone; either locally through the
programming port or remotely by calling in to the unit.
Local Programming
A standard RJ11 Telephone jack has been provided. This port accepts a
standard TouchTone telephone set and is used to record voices or
perform basic, programming tasks. DO NOT PLUG A TELEPHONE
LINE INTO THIS PORT.
To begin a local programming session, lift the handset to your ear.
The B1277 has stored voice prompts to guide you through the
programming session. The first message you will hear is “Enter
Command Code” followed by a pause, and then, "Enter Program
Code". Refer to the Handset Programming Codes on Page 10 for a list
of Program Codes and the subsequent pages for instructions on
programming each section.
Remote Programming
For a remote session, call in to the B1277 from your TouchTone
telephone set.
When answering an incoming call, this unit responds depending on the
previously programmed Security Level setting:
Level 1: The call will be answered with a message containing the
Site ID, any Groups that have alarms, followed by the
prompt "Enter Command Code". An Access Code is not
required.
Level 2: The call will be answered with a message containing
only the Site ID. To advance any further the caller must
enter the Access Code within 10 seconds.
Level 3: The call will be answered with the device emitting short
beeps. To advance any further the caller must enter the
Access Code within 10 seconds.
If the unit’s security level is set to Level 1, or the Access Code was
successfully entered, the B1277 will say “Enter Command Code” and
then pause for several seconds. If the Access Code is entered again,
or the Access Code is blank, the unit will enter the programming
mode and speak “Enter Program Code”. At this time you can enter
your program codes using the Program Summary on Page 10.