OPERATIONS
PAGE 30
Power Switch
This small pushbutton switch is located next to the serial connector and is
used to bring the system out of low power mode, put the system back into
low power mode and to shut the system down when it is operating from
battery only.
When the Cv3 is in low power mode, it will show only a blinking run
indicator. Pressing the power switch briefly will restore operation to full
power.
While the Cv3 is operating at full power, pressing the switch briefly will
force it into low power mode. The unit cannot be forced into low power
operation if alarm reporting activities are taking place.
When the Cv3 is disconnected from the primary power source and
operating from the internal battery, pressing the power switch
continuously for 5 seconds will cause the unit to power down. Normal
operation will be restored when primary power is restored.
