Barnes 4SCC Series, Installation And Operation Manual

Page: 4 / 28

4
DISCHARGE ................................. 4” NPT, 125 lb. Flange Horizontal
LIQUID TEMPERATURE ............... 104°F (40°C) Continuous
VOLUTE ........................................ Cast Iron ASTM A-48, Class 40B
MOTOR HOUSING ........................ Cast Iron ASTM A-48, Class 25
SEAL PLATE ................................. Cast Iron ASTM A-48, Class 25
IMPELLER: Design ...................... 2 Port, Enclosed, Dynamically
Balanced ISO G6.3
Material .................... Austenitic Cast Iron, ASTM A436-80-55-06
CUTTER CONE .............................. Integral with Impeller, Hardened Steel
52/53 Rockwell "C"
CUTTER BLADE ............................ Hardened Steel, 45/47 Rockwell "C"
SHAFT .......................................... 416 Stainless Steel
SQUARE RINGS ............................ Buna-N
LIFTING DEVICE ........................... Y oke
HARDWARE .................................. 300 Series Stainless Steel
PAINT ............................................ Air Dry Enamel.
SEAL: Design ...................... Tandem Mechanical, Oil Filled Reservoir
Material Inbord ...................... Rotating Faces - Carbon
Stationary Faces - Stainless Steel
Elastomer - Buna-N
Hardware -300 Series Stainless
Outbord .................... Rotating Faces - Tungsten Carbide
Stationary Faces - Tungsten Carbide
Elastomer - Buna-N
Hardware -300 Series Stainless
CORD ENTRY ................................ 30 ft. (9m) Std. Cord. Pressure Grommet
for Sealing and Strain Relief
SPEED ........................................... 1150 and 1750 RPM (Nominal)
UPPER BEARING:
Design ...................... Single Row, Ball, Grease Lubricated
Load ...................... Radial
LOWER BEARING:
Design ...................... Double Row, Ball, Grease Lubricated
Load ...................... Radial & Thrust
MOTOR: Design ...................... NEMA B - Three Phase Torque Curve.
Air-Filled, Squirrel Cage Induction
Insulation .................. Class F.
THREE PHASE .............................. Dual Voltage 230/460; Includes
Overload Protection in Motor.
MOISTURE SENSOR .................... Normally Open (N/O), Requires Relay in
Control Panel
TEMPERATURE SENSOR ............ Normally Closed (N/C), Requires Relay in
Control Panel
OPTIONAL EQUIPMENT ............... Seal Material, Impeller Trims,
Cord Length
SECTION: A - PUMP SPECIFICATIONS:
IMPORTANT !
1.) PUMP MAY BE OPERATED “DRY” FOR EXTENDED PERIODS WITHOUT DAMAGE TO MOTOR AND/OR SEALS.
2.) THIS PUMP IS APPROPRIATE FOR THOSE APPLICATIONS SPECIFIED AS CLASS I DIVISION II HAZARDOUS LOCATIONS.
3.) THIS PUMP IS NOT APPROPRIATE FOR THOSE APPLICATIONS SPECIFIED AS CLASS I DIVISION I HAZARDOUS LOCATIONS.
4.) INSTALLATIONS SUCH AS DECORATIVE FOUNTAINS OR WATER FEATURES PROVIDED FOR VISUAL ENJOYMENT MUST BE INSTALLED IN
ACCORDANCE WITH THE NATIONAL ELECTRIC CODE ANSI/NFPA 70 AND/OR THE AUTHORITY HAVING JURISDICTION. THIS PUMP IS NOT
INTENDED FOR USE IN SWIMMING POOLS, RECREATIONAL WATER PARKS, OR INSTALLATIONS IN WHICH HUMAN CONTACT WITH PUMPED
MEDIA IS A COMMON OCCURRENCE.