Barnes 2020HC, Installation And Operation Manual

Page: 4 / 12

4
SUCTION/DISCHARGE . 2” (51mm) x 2” (51mm) NPT Female
LIQUID TEMPERATURE 160°F (71°C) Continuous
BODY ............................. Cast Iron ASTM A-48, Class 30
INTERMEDIATE ............. Cast Iron ASTM A-48, Class 30
IMPELLER
Design ........... Enclosed type
Material ........ 81-3-7-9 Bronze
Dynamically Balanced, ISO G6.3
WEAR RING ................... Tefl on “U” cup
SHAFT ............................ Steel
SHAFT SLEEVE ............ Bronze
HARDWARE .................. Steel
PAINT ............................. Air dry enamel
SEAL: Design .......... Single Mechanical
Lubrication.... Self-Lubrication
Material ........ Rotating Faces - Carbon
Stationary Faces - Ni-Resist
Elastomer - Buna-N
Hardware - 300 series stainless steel
CHECK VALVE .............. 2” (51mm) Discharge
Material ........ Valve Flap-Neoprene
Weights - Cast Iron, ASTM A-48
Class 30
BASE.............................. Steel with Carring Handles
STRAINER ..................... 2” (51mm) Suction, Steel
PRIMER .......................... Exhaust, with 0-150 PSI Compound
Pressure and Vacuum Gauge
ENGINE:
Make/Model........ Briggs & Stratton 245400, Gasoline
Type ................... 4 Cycle, Single Cylinder, Air Cooled
Displacement ..... 24 Cu. In.
Oil Capacity ........ 51 Fl. Oz
Air Cleaner ......... Dual Element
Fuel Tank ........... 7.5 Quarts
Start Method....... Recoil Rope
Rated.................. Max. Dynamic B.H.P. 13 @ 3600
Throttle ............... Manual
OPTIONAL EQUIPMENT . Wheel Kit
SECTION: A - PUMP SPECIFICATIONS:
inches
(mm)
IMPORTANT!
1.) DO NOT USE FOR PUMPING FLUIDS WITH A FLASH POINT OF LESS THAN 100°F.
2.) MAKE CERTAIN THAT PUMP AND/OR MOTOR ASSEMBLY AND CONTROLS HAVE THE APPROPRIATE RATINGS FOR THE GIVEN
APPLICATION AREA CLASSIFICATION (ie DIVISION I, AGENCY LISTING ETC.)