User Manual
Page 6
TESTS &
TROUBLE-
SHOOTING
NOTES
FOR USE
1) Take out the test bulb from the package and put it on the Receiver
device’s contact points.
2) Press Mode button of Remote transmitter, switch to Shock Mode,
confirm that LCD display is not 0 by pressing UP/DOWN button on
the right side to adjust.
Please make sure that the remote and the receiver collar have been
synced successfully.
Please make sure that the remote and the receiver collar have been
synced successfully.
TEST THE STATIC SHOCK FUNCTION
Press the Mode button switch to Shock mode
Press the Y button and the test bulb will flash; that means Shock
function works.
TEST THE VIBRATION FUNCTION
Press the Mode button switch to Vibration mode
Press the Y button, Receiver device will vibrate; that means Vibration
function works.
TEST THE BEEP FUNCTION
Press the Mode button switch to Beep mode.
Press the Y button, Receiver device will create a tone; that means beep
function works.
TEST THE LED LIGHT FUNCTION
Press the Mode button switch to Beep mode.
Press the Y button, Receiver device will flash, signifying that the LED
Light function works.
1.
The lifetime of the device will vary according to how often you use the
product.
2.
Valid distance of Controller means straight-line distance between the
Controller and the Receiver Collar without obstacles in between. If there
are interference signals or signal screening around, the actual remote Con-
troller distance may vary.
3.
Only through training, can the pet understand the intention of its owner.
Good effect can only be achieved after a period of training.
4.
Training sessions should be kept positive and short, about 10-15 minutes
long each time.
5.
Presently, this product is the most effective and safest tool for training
pets.
By following the correct operational instructions, you can effec-
tively train the pet and bring it no harm.
