STEP 9
Type in <0> and hit <enter> to enter the Network
configuration. Enter all requested values:
STEP 10
Type in <9> and hit <enter> to save the Network
configuration.
Please continue with section “Next steps”.
Network configuration using telnet
STEP 1
Unplug the power supply of the Exstreamer.
STEP 2
Keep the Reset button pushed and plug in the power
supply. Release the Reset button after 5 seconds.
STEP 3
Run a command session. Type telnet in the run window
with the IP address announced by Sonic IP on port 9999.
Example: telnet 192.168.0.12 9999
You will see the following screen:
Hit <enter> to access the Exstreamer in the setup mode.
STEP 9
Type in <0> and hit <enter> to enter the Network
configuration. Enter all requested values.
STEP 10
Type in <9> and hit <enter> to save the Network
configuration.
Next steps
STEP 1
Download the user manual from www.barix.com.
STEP 2
Check the section “Updating the device”.
STEP 3
Check the section “IR Remote control” on how to install
the IR serial receiver.
STEP 4
Check out the Barix user forum on www.barix.com for
additional information.
Alternative “Streaming Client” firmware
Please visit www.barix.com and download the “Streaming
Client Update Package”. This alternative firmware
supports WMA and MP3 streaming (http, UDP, RTP) with
automatic failover and USB flash memory playback.
Support
For support please contact your local dealer or visit
www.barix.com.
© Barix AG 5/2006, all rights reserved.
All information is subject to change without notice.
All mentioned trademarks belong to their respective
owners and are used for reference only.
Barix, Exstreamer, SonicIP and IPzator are trademarks of
Barix AG, Switzerland, and are registered in certain
countries.
For information about our products, manuals, technical
documentations and latest version of firmware please visit
www.barix.com.
Barix AG
Seefeldstrasse 303
8008 Zürich
SWITZERLAND
www.barix.com
