Network configuration by web browser
STEP 1
Open your web browser.
STEP 2
Enter the IP address of the Exstreamer and press Enter.
Example: 192.168.0.12
STEP 3
Click on the Config link:
STEP 4
Enter an IP address into the 4 IP address fields. At default it
is 0.0.0.0 for automatic. You can use the address that was
announced by the Exstreamer.
STEP 6
In normal operating conditions leave the Netmask as is.
STEP 5
The Gateway, primary and alternative DNS IP addresses as
well as Sonic IP can be left at default for now.
STEP 7
Hit the Apply button to save all changes. The Exstreamer
will reboot with the Static IP address.
Please continue with section “Next steps” on last page.
Network configuration using supplied
serial cable
STEP 1
Open a Terminal program.
STEP 2
Go to the settings menu of the terminal program and
adjust the following settings:
Baud rate 9600 bit/sec, 8 Data Bits, no Parity, 1 Stop Bit
STEP 3
Unplug the power supply of the Exstreamer.
STEP 4
Connect the supplied serial cable to your PC’s COM port
and to the serial port of the Exstreamer.
STEP 5
Keep the Reset button pushed and plug in the power
supply. Release the Reset button as soon as you see the
following screen:
STEP 6
Hit <s> to skip network discovery if not connected to a
network and the following screen appears:
STEP 7
Hit <s> to get to the Exstreamer setup.
STEP 8
Hit <enter> to enter the Exstreamer setup mode.
