Package content
a Exstreamer
100
b Power
supply
Front view
1 2 3 4 5
1 Reset
button
Press this button shortly to reset the device.
If you press it until the red light flashes (about 5
seconds) the device will be reset to factory defaults.
2 USB 1.1 interface (only supported in Streaming Client
firmware available on www.barix.com)
3 Green LED for status display
4 Red LED for status display
3 Headphone
out
Installation
STEP 1
Plug a network cable ( e ) into the network port (C) of the
Exstreamer and the other end into your hub or switch.
You can also use a crossover network cable (not included)
for a direct connection to your PC.
STEP 2
Plug a earphone ( c ) into the headphone output ( 5 ) and
put it in your ear. Get a pen and paper ready to write
down the IP address that will be announced in step 4.
STEP 3
Plug the power supply (b) into the
power jack ( D ) of the
device and the other end into the power outlet of the wall.
STEP 4
The Exstreamer will now search for a DHCP server to get
an IP address and announce it over the earphone.
Example:192.168.0.12 (Voice: one nine two…)
Make sure you write this IP address down.
Cable Set AUDIO
(not included)
c Earphone
d
RCA stereo cable
e Network
cable
f Serial
cable
Rear view
A B C D
A Headphone out
B Stereo RCA line output
C RJ45 for LAN 10/100 Half/Full duplex
D DSub9 male, Serial port (RS-232)
E Power in
If no DHCP server is found then our IPzator function will
search the network for a free IP address (this could take up
to 5 minutes). If the IP address is not announced check if
the green LED (right LED on top of network port C) is lit.
If it stays dark check your network cabling. If the front
LEDs (3 and 4) stay dark check the power cabling (step 3).
If it still fails revert the device to factory defaults by
pressing the Reset button for about 5 seconds while the
Exstreamer is powered.
Your Exstreamer is now ready to start working. We
recommend, however, that you set a Static IP address.
See next pages on how to do this or download the user
manual from www.barix.com.
