TRANSMITTER BUTTON OPERATION
IMPORTANT: The microprocessor alarm system has been designed so that upon arming, Shock
Sensor and door triggers will be delayed for 20 seconds. This is to give the electronics in the vehicle,
a chance to stabilize (Window roll-up, radar sensor, dome light etc.).
WARN-AWAY
Dual zone shock sensor, zone one when triggered causes the alarm to chirp five times indicating a Warn-
away condition, second zone when active, triggers the Alarm.
VALET MODE
Valet mode entry
. Disarm the alarm, turn the Ignition ON, and hold the push button valet switch for 5
seconds until LED turns ON. Door lock/ unlock, and all aux outputs respond to transmitter (Keyless Entry).
Valet mode exit
.
Turn the Ignition ON; hold the push button valet switch for 5 seconds until LED turns
OFF and siren chirps two times.
EMERGENCY OVERRIDE
Disarming the alarm without transmitters. Turn Ignition ON, hold the push button valet switch down for 5
seconds, the siren will turn off and alarm will disarm.
SENSOR DISABLE FEATURE (ONE WAY REMOTE )
Disable the sensors for a single arm cycle, by pressing the button one to Arm and within 10 seconds pressing the
button one again siren will chirp once. That will disable sensor for that arm cycle. Rearming the alarm will re-
enable the sensor.
SENSOR DISABLE FEATURE (TWO-WAY REMOTE )
Disable the sensors for a single arm cycle, by pressing the button one to Arm and within 10 seconds pressing
button # 1 and button # 4 together siren will chirp once. That will disable sensor for that arm cycle. Rearming
the alarm will re-enable the sensor.
ACCIDENTAL DISARM (AUTO REARMING)
If the alarm has been armed for at least 20 seconds and has been disarmed with the transmitter by mistake. It
will automatically rearm within 30 seconds. Opening the door or turning on the ignition key will cancel
rearming. If this feature is programmed it will always be active no matter if the alarm is in active or passive
mode.
To enable this feature, go to program locatio #2 and turn this feature to mode 2.
DOOR TRIGGER DELAY IN PASSIVE MODE
If enabled, when the alarm arm’s passively, upon opening the door siren will chirp for 10 seconds then will
trigger the alarm, unless you turn the ignition on within that 10 seconds. This will disarm the system. This
enables you to use the alarm without remote. If the alarm has been triggered refer to VALET mode.
7A- ANTI - CAR JACKING W/ REMOTE (WITH ONE WAY REMOTE):
To activate the Car Jacking feature, Ignition should be (ON) If The Remote Shift than Button #4 is Pressed
90 seconds later the siren will chirp for 15 seconds to remind you that the system will be in car jacking mode. After
the reminder, the parking lights will flash & the siren will sound for 5 minutes, and the (-) Orange wire (Starter
kill) will be activated.
7A- ANTI - CAR JACKING W/ REMOTE (WITH TWO-WAY REMOTE):
To activate the Car Jacking feature, Ignition should be (ON) If Remote Buttons #1 and #2 are Pressed
90 seconds later the siren will chirp for 15 seconds to remind you that the system will be in car jacking mode.
To turn the car jacking mode OFF, Ignition should be (ON) and press VALET switch 3 times to reset .
7B- ANTI - CAR JACKING W/ DOOR:
To activate the Car Jacking feature, Ignition should be (ON) If Door is opened 90 seconds later the siren will
chirp for 15 seconds to remind you that the system will be in car jacking mode. After the reminder, the parking
lights will flash & the siren will sound for 5 minutes, and the (-) Orange wire (Starter kill) will be activated.
To turn the car jacking mode OFF, Ignition should be (ON) and press VALET switch 3 times to reset.
PROGRAMING TRANSMITTERS
Open the door, Turn the ignition key 3 times on/off, on/off, on leave the ignition key in ON position, siren
will chirp 1 time.
Press valet switch 5 Times the siren will chirp 5 times, then press button # 1 on the remote transmitter one
time. The siren will chirp once. If you want to teach another transmitter with a different code press button #
1 one time on the second transmitter the siren will chirp once. You can teach 4 different codes. Also two-way
TRANSMITTER TEACHING FOR SECOND CAR OPERATION
Same as programming transmitter, press side button # 5 (function button) 2 times then press button # 1, siren
will chirp once.
ALARM SPECIAL FEATURES
ACTIVE ARMING MODE
Press transmitter button #1
momentarily to arm the alarm system. The alarm will disarm and the
siren will chirp once, sidelights will blink, doors will lock automatically, optional starter disable feature
will be activated and the LED will turn on solid then begin flashing slowly after
a 20 second delay.
DISARMING THE SYSTEM ( One-way Remote)
Press transmitter button #2
momentarily to disarm the alarm system. The alarm will disarm and the
siren will chirp twice, sidelights will flash twice LED will turn off Optional starter disable feature will be
deactivated Door locks will unlock automatically Dome light will be illuminated for 30 seconds or until
ignition key is turned to accessory “ON” position.
DISARMING THE SYSTEM ( Two-way Remote)
Press transmitter button #1
momentarily to disarm the alarm system.
ARMING WITH (NO CHIRP One way Transmitter)
Press transmitter side button #5 momentarily. Then press button #1
the alarm will arm silently (no
siren chirps).
DISARMING WITH (NO CHIRP One-way Transmitter)
Press transmitter side button #5 momentarily. Then press button #2
the alarm will disarm silently (no
siren chirps).
PASSENGER DOOR UNLOCK (One-way Transmitter)
Press Button # 2
and whiten 10 seconds press button # 2 agene Blue/White wire will unlock
Passenger Door.
PASSENGER DOOR UNLOCK (Two-way Transmitter)
Press Button # 1
and whiten 10 seconds press button # 1
agene and hold for 3 seconds then release
Blue/White wire will unlock Passenger Door.
PASSIVE ARMING MODE
In passive arming mode, upon closing the last door there will be a 30 second arming delay. The LED will
be flashing rapidly. After 30 seconds, the alarm will arm (Programmable).
ARMING WITH DEFECTIVE ZONE ALERT
After arming the alarm (active or passive). If a defective zone has been detected. The alarm will confirm
the detection of the defective zone by chirping the siren and flashing the lights 5 times. All defective zones
will be bypassed until you disarm and arm the unit.
PANIC MODE (One-way Transmitter)
For emergency situations, press and hold button #1,
of the transmitter for 3 seconds. This will activate
the panic mode. The alarm siren will sound, armed output will be active, doors will lock and the parking
lights will flash for 30 seconds (or until the transmitter button #1 or #2 is pressed.
PANIC MODE (Two-way Transmitter)
For emergency situations, press and hold button #1+2 together,
+
of the transmitter for 1 second.
This will activate the panic mode. The alarm siren will sound, armed output will be active, doors will
lock and the parking lights will flash for 30 seconds (or until the transmitter button #1 is pressed and
released.
ALARM TRIGGERED
If a violation of the vehicle is taking place, the siren will sound, horn will flash, and the parking lights
will flash for 45 seconds. After this 45 seconds duration, the alarm will automatically reset and resume
protecting the vehicle. Sensor 1 sensor 2 triggers will sound the alarm 30 seconds.
INTRUSION ALERT
If a sensor input (door switch, shock sensor) has been violated while the system was armed, upon
disarming the alarm system, the siren will confirm with 3 disarming siren chirps and 3 light flashes
indicating the alarm had been tripped. Turning the ignition to on position the LED will flash 8 cycles
indicating the trigger zone,
3
6
