Bard W48A2PQ, Installation And Service Instructions Manual

Page: 64 / 82

Manual 2100-642
Page 64 of 82
Screen Menu Item Range Default Value Description
1 MAIN STATUS SCREEN
Date and Time
Displays current date and time
Zone 1 Temp Degrees Disaplays zone temp
Zone 2 Temp Degrees Display zone temp if enabled
Zone 3 Temp Degrees Display zone temp if enabled
Zone 1 Humidity % RH Display zone humidity if enabled
Zone 2 Humidity % RH Display zone humidity if enabled
Zone 3 Humidity % RH Display zone humidity if enabled
Status
Comfort Mode/
Normal/Off
Current mode of operation
2-4 Humidifier Screens Dependant on number of units enabled
Humidifier 1 Request 0-100% If humidifiers are enabled
Production Kg/Hr. If humidifiers are enabled
Current Amps If humidifiers are enabled
Conductivity us/cm If humidifiers are enabled
5-16 Unit Screens Dependant on number of units enabled
Return Air Temperature Degrees
Current return air temp for unit address
displayed
Mixed Air Temperature Degrees
Current mixed air temp for unit address
displayed
Outdoor Air Temperature Degrees
Current outdoor air temp for unit
address displayed
Outdoor Air Humidity Degrees
Current outdoor air humidity for unit
address displayed
Blower On/Off
Current blower status for unit address
displayed
Damper % Open
Current damper status for unit address
displayed
17-28 Last hour tracking Dependant on number of units enabled
Free Cooling Run Minutes
and Starts
Minutes/Starts If applicable
Cooling 1 Run Minutes and
Starts
Minutes/Starts
Number of compressor run minutes and
starts
Cooling 2 Run Minutes and
Starts
Minutes/Starts If applicable
Heating 1 Run Minutes and
Starts
Minutes/Starts
Number of heater run minutes and
starts
Heating 2 Run Minutes and
Starts
CAUTION: The Bard 575 volt wall mount unit system has been pre-programmed with what is widely considered to be
the best settings for efficiency and operation. Any changes to internal programming through the LC-Series controller
or the TEC-EYE not covered within this manual may cause the systems to operate improperly, cause internal damage
to the HVAC units, cause the shelter to overheat or other very serious consequences. Although complete controller
programming architecture for both the LC-Controller and TEC-EYE has been provided, going outside the boundaries
of what has been covered in this manual is not recommended.
APPENDIX: LC-SERIES CONTROLLER AND
TEC-EYE ARCHITECTURE