Bard W48A2PQ, Installation And Service Instructions Manual

Page: 22 / 82

Manual 2100-642
Page 22 of 82
One additional temperature sensor can be added to Zone 1 and additional temperature/humidity sensors may be
added to Zones 2 and 3 (one per zone).
Be sure the sensors are connected to the proper terminals as listed below.
FIGURE 1.13
Additional Remote Temperature and Temperature/Humidity Sensor Installation
For proper operation, the remote indoor temperature/humidity sensor must be configured properly with the
controller. If only the single remote indoor temperature/humidity sensor supplied with the controller is installed, the
configuration setting is "0". This is the default setting. An additional remote indoor temperature-only sensor can be
purchased and installed in Zone 1. Also, temperature and humidity sensors can also be purchased and installed
in Zones 2 and 3 (one per zone). For information on remote indoor sensor configuration, see section on additional
sensors
beginning on page 46.
10 4 3 2 29 1 6 7 8 9 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 5 26 27 28
MIS-3730
Zone 1:
Optional Remote
Temperature Sensor
Terminals 8 & 9
*
Zone 2:
Optional Remote
Temperature/Humidity Sensor
Terminals 10, 11, 20, 21 & 22
* The two wire connections for the optional remote temperature
sensor are not polarity sensitive.
TB#
Wire
Mark
Description
8 B2 Indoor Remote Sensor (Zone 1 – optional)
9 GND Ground
Zone 3:
Optional Remote
Temperature/Humidity Sensor
Terminals 12, 13, 14, 15 & 16
TB#
Wire
Mark
Description
12 B4 Indoor Remote Sensor (Zone 3)
13 GND Ground
14 B5 Remote Indoor Humidity Sensor: 0-1 VDC (Zone 3)
15 GND Ground
16 +VDC Power for B5
TB#
Wire
Mark
Description
10 B3 Indoor Remote Sensor (Zone 2)
11 GND Ground
20 B7 Remote Indoor Humidity Sensor: 0-1 VDC (Zone 2)
21 GND Ground
22 +5V ref Power for B7