Barco XLM H25, Owner'S Manual

Page: 36 / 111

3. Connections
RS232/422 Serial Network OUT
3 TXB- Transmitted Data (TD or TX or TXD) 8
-
4TXB+ Data Terminal Ready (DTR) 9
-
5 GND Signal Ground (GND)
- -
3.4.2 Ethernet connection
Connection
Connect port 1 or port 2 to a LAN by using a straight cable or a crossed cable. The connection is a 10/100 baseT.
MONITOR OUT
2 1
3
PUSH
2 1
3
PUSH
HARDWIRED REMOTE 10/100 BASE T SERIAL NETWORK
MONITOR OUT RS232/422 OUT RS232/422 IN
WIRELESS REMOTE
CTRL 3 CTRL 2 CTRL 1 PORT 1 PORT 2
BI-DIRECTIONAL UNI-DIRECTIONAL
Image 3-20
Ethernet connection
The projector must have an IP address and the IP address of the connected PC must be within the same range of IP addresses.
Once getting access, it is possible to check and manipulate all projector settings. Remote diagnostics, control and monitoring be-
come very simple.
The 2 ports are functionally identical. Both ports are connected via the projector hub.
Pin configuration
Ethernet 10/100 base T Port 1 & 2
1 TXD+ 5 ++2.5VA
2 TXD- 6 RXD-
3 RXD+
7
RXD-
4 ++2.5VA 8 GNDM
3.4.3 Hardwired remote to CTRL 1
How to connect
1. Plug one end of the remote cable in the connector on the bottom of the RCU. (image 3-21)
2. Plug the other end in the connector in the input panel of the projector labelled CTRL 1.
Specifications of the CTRL 1 input:
- U
in
= 9V
- I
max
= 80 mA
Internal IR receiver can be disabled:
o
mono jack : on plug in of the jack
o
stereo jack : on plug in or using an external switch bringing the right channel (B) to ground level. (image 3-22)
32 R5976690 XLM H25 03/09/2004