Barco SLite, Service Manual

Page: 23 / 53

5. On Screen Display messages
5. ON SCREEN DISPLAY MESSAGES
General
An SLite tile can generate and display several “On Screen Display” (OSD) messages regarding parameter statuses of the tile. Most
of those messages can be displayed on request via the XLite toolset. Other OSD messages are automatically displayed in case an
error occurred. Those error messages are displayed in red. Most OSD messages are displayed for a time period of 10 seconds
or continuous, depending the XLite toolset settings. Some are displayed for a time period of 3 seconds and repeated after a time
interval of 25 seconds.
5.1 OSD messages
List with OSD messages:
OSD
message Description
SOFT
1.01
BOOT
1.0
Displaying of software version flash-code (normal working program) and software version boot-code.
Software versions can be displayed on request via the XLite toolset.
FIRM
B1.02
C1.01
01.02
Displaying of software version firmware front-FPGA, firmware back-FPGA and firmware re-sync unit.
Firmware versions can be displayed on request via the XLite toolset.
FIRM
B1.02
C1.01
XX.XX
Displaying of software version firmware front-FPGA, firmware back-FPGA.
I 2 C error while reading firmware re-sync unit or feature not available.
Firmware versions can be displayed on request via the XLite toolset.
ADDR.
14
Displaying tile address. Note that all devices in the data chain has an address number, starting with the master
digitizer having address “1”. The address number increments for all following devices in the data chain.
Each digitizer, fiberlink transmitter, fiberlink receiver, AEC and all tiles in the data chain are considered as a
device with a unique address.
Address number of the tile can be displayed on request via the XLite toolset.
TEMP.
34°C
93°F
Displaying the temperature inside the tile in degrees Celsius and degrees Fahrenheit.
Tile temperature can be displayed on request via the XLite toolset.
DCONT
R 36
G 36
B 36
Displaying the RGB values set for digital contrast. These values can be changed between 0 and 255 using
the XLite toolset.
Digital contrast values can be displayed on request via the XLite toolset.
ACONT
R 850
G 800
B 600
Displaying the RGB values set for analog contrast. These values are factory pre-adjusted.
Analog contrast values can be displayed on request via the XLite toolset.
HPOS
370
→
434
Displaying the start pixel row and end pixel row of the tile in the complete LED-wall. The origin is always
left top of the display.
The horizontal window position can be displayed on request via the XLite toolset.
R5976621 SLITE DISPLAY 02/09/2005 19