![background image](http://html1.mh-extra.com/html/barco/r9828870/r9828870_instruction-manual_4243734016.webp)
BARCO 16 Projection Systems
Projector position correction
What has to be
done
After the Projector/support is attached to the rods, small corrections on the position of
the projector with regard to the screen has to executed, as water-level and perpendicu-
larity of the projector to the screen.
Necessary Tools
Spanner 18mm -Flat screw driver
A
CD
B
H
Projector COARSE
water-level
adjustment
To level (Coarse) the projector, follow the next procedure:
Step
Action
1-
Loosen the nuts 1 on each rod and move these 2 cm upwards
2-
Put a water-level on the projector, as well on the long side as on the short side
of the projector support, and level of the projector using the nuts 2.
Warning: always ensure that the nut 3 on each rod remains fully screwed
on the rod.
3-
Secure the position of the projector/support by fastening the nuts 1 and 3.
Projector FINE
water-level
adjustment
To level (Fine) the projector, follow the next procedure:
Step
Action
1-
Loosen the safety-nut (C) on top and rear of the projector support.
2-
Adjust the adjustable screw (A) on each side of the projector support to apply
small correction to the coarse water-level adjustment. (turning clockwise lifts up
the projector, counterclockwise lowers the projector)
3-
Secure the position of the projector/support by fastening the safety-nuts (C).
A
Nut 1
Nut 2
Nut 3
C
C
Illustrations