![background image](http://html1.mh-extra.com/html/barco/r9040411/r9040411_user-manual_4242996124.webp)
5. Advanced
3. Press
↓
to Pull down the
Display setup
menu
4. Use
↑
or
↓
to select
Textbox
5. Press
→
to pull down the menu
6. Use
↓
or
↑
to enable (
ON
) or disable (
OFF
) the textbox
Image 5-130
7. Press
ENTER
A white bullet shows the active setting
5.9.2
Stereo display settings
Overview
•
•
It is not possible to show an interlaced source in stereoscopic mode.
5.9.2.1
Introduction
The
Stereo display settings
allow us to set what happens on the display side (output side) whereas the
Input
stereo sync
in the
Image
menu is done at the input of the projector
Mono Sources
When a mono source is connected to the projector, following settings can change the way it is displayed :
•
Full screen synchronous representation, see "Full screen synchronous representation", page 121
•
Stereo Mode, see "Stereo Mode ", page 120
Following illustrations give an overview on how (how = synchronous or asynchronous and which refresh rate) a mono source will be
displayed in function of its vertical refresh rate and for the different settings mentioned above. A mono source means that no stereo
sync is connected.
118
R59770718 GALAXY NW SERIES 20/06/2013
Summary of Contents for R9040411
