Barco R9002120, Installation Manual

Page: 20 / 34

Power Connection
6-2 5975987 BARCODATA 708 260597
Retaining screws
- Loosen both screws of the protective cover and take off the cover.
230 V 120 V
- Pull out the 'power selector plug' and re-insert it as illustrated,
depending on the walloutlet in the room.
- Re-mount the protective cover and secure with both screws.
- Re-insert the module.
- Put the plastic cover back and secure both retaining screws.
Fuses
Warning
For continued protection against fire hazard :
- replace with the same type of fuse
- refer replacement to qualified service personnel
Fuse type : 2 x T5A/250V (Barco order number : R314104)
Switching on/off
The projector is switched ON and OFF using the power (mains)
switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image dis-
played) or in the 'stand by mode', depending on the position of the
'power up' dip switch on the controller unit. This DIP switch is set
during installation by a qualified technician. If you want to change this
start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
-9
V
SF
HO
L
D
DO
W
N
EHT
S
T
A
NDBY
-C
O
N
V
-1
7
V
+1
7
V
+H
TH
D +C
ON
V
+9
V +2
1
0
V
+3
0
V
AAAA
AAAA
AAAA
AAAA
AAAA
CO
IN
C
HO
L
D
DO
W
N
HD
Leds on the front plate of the projector