Barco R9002120, Installation Manual

Page: 19 / 34

Power Connection
6-1 5975987 BARCODATA 708 260597
6
POWER CONNECTION
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall
outlet. Plug the female power connector into the male connector at
the front of the projector.
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF ON
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF ON
Input power (mains) voltage adaptation.
Attention
The BARCODATA 708 - R9002120 leaves the factory to operate on
a mains (power) input of 230 Vac.
Adaptation of the power input of the projector from 230 VAC to 120
VAC or vice versa is possible. Follow the procedure as described
below.
Procedure
- Unplug the power cord from the power input on the front panel.
- Remove the front panel by loosening both retaining screws and take
off the plastic cover plate.
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF
ON
- Pull out the module.