Source connections
7-3
5975857 BARCOGRAPHICS 1208s 220197
Procedure to remove the line termination resistors :
➊
Turn off the projector and unplug the projector power cord.
➋
Remove the top cover from the projector (see p.4-1).
➌
Take out the RGB Input Auto Sync Tracking Module from the main
frame.
➍
Unsolder and remove the resistors.
To take out the RGB Input Auto Sync Tracking Module, follow the
same procedure as described in p.4-2 for taking out the Horizontal
Deflection module :
➊
press the module lock and lift up the module handle;
➋
repeat this action on both sides of the module and extract the
module out of the main frame.
Blue in Green Switch
Blue characters are difficult to read, therefore the blue text will be
displayed as cyan so that the readability becomes better.
Switch in the ON position : blue in green active.
Switch in the OFF position : blue in green disabled.
WARNING : Leaving the switch in the ON position will result in
abnormal colour balance of the projected image.
Force Negative Sync
Switch in the ON position : the sync pulses must be negative.
Switch in the OFF position : the sync polarity will be automatically
detected.
Connecting a RGB Analog source to Port 4/5
RGB analog input terminals with separate H and V sync inputs, with
composite sync input or with sync signals on green can be connected
to the projector via Port 4/5. The projector detects automatically where
the sync signal is located.
It is recommended to use an interface when a computer and local
monitor have to be connected to the projector. BARCO provides the
following interfaces :
❒
Universal Analog Interface - Order number : R9826100.
❒
RGB 120 MHz Analog Interface - Order number : R9826570.
To select the RGB input :
with the RCU or the local keypad : press the numeric button 4 or 5.
Connecting a Component Video source to
Port 4/5
A component video (R-Y, Y, B-Y) with sync signals can be connected
to the projector via Port 4/5. The projector detects automatically where
the sync signal is located.
It is recommended to use an HDTV interface when a computer and
local monitor have to be connected to the projector. BARCO provides
the Kit HDTV - Order number : R9828040.
To select the component video input :
with the RCU or the local keypad : press the numeric button 6.
RGB Input Auto Sync Tracking Module
798
VCR HDTV player
Audio amplifier
75 ohm
OFF ON
PORT 1
(VIDEO)
PORT 4/5
(RGB - HV)
Comp/H sync V sync
R
G
B
PORT 3
PORT 6
RE MOTE
COMMUNICATION
PROJECTOR MODE
POWER/MAINS
PORT 2
(S-VIDEO)
75 ohm
ON
OFF
GREEN : operational
RED : stand-by
75 ohm
OFF ON
PORT 1
(VIDEO)
PORT 4/5
(RGB - HV)
Comp/H sync V sync
R
G
B
PORT 3
PORT 6
REMOTE
COMMUNICATI ON
PROJECTOR MODE
POWER/MAINS
PORT 2
(S-VIDEO)
75 ohm
ON
OFF
GREEN : operational
RED : stand-by
INP
INP
R
G
B
H
V
INPUT
ANALOG INTERF. 120MHz
ON
OFF
inver .
75 oh m ter m.
363