![background image](http://html.mh-extra.com/html/barco/r767302k/r767302k_instructions-manual_474433032.webp)
24-1701050-00 /01
EC-200 to EC-210 Conversion Kit
32
Coil and tie wrap the extra length of the HDMI output (
“
Screen 3
”
) cable.
6.
Connect one end of the 18" single link DVI-D male-to-male cable (90409628EF) from the right-side display
assembly to the DVI connector at the DVI1 header.
7.
Connect the 20
–
pin connector of the USB cable from the display assembly to the USB78 connection.
Note:
It is important
that you apply some silicone sealant or RTV silicone to the 20-pin USB78
connector, near the polarizing post (see Image 2-25), to prevent this connector from coming loose
during handling or transit.
Image 2-36: HDMI output, DVI-D male-to-male cable, DisplayPort-to-left side cable,
USB from the display assembly, and DVI to HDMI pigtail adapter connections
1
HDMI Output (
“
Screen 3
”
) to
the HDMI connector at the
DP1+HDMI header
2
18" single link DVI-D male-
to-male cable
(90409628EF) at the DVI1
header
3
DisplayPort-to-left side
cable at DPI+HDMI1
4
USB from the display
assembly at the USB78
connector (cable not shown)
See Image 2-37 for a view
of USB78 and USB910 with
cables inserted.
5
DVI to HDMI pigtail adapter
to the HDMI cable from the
HDMI Input
Image 2-37: USB connections from display assembly and from right side of keyboard
1
USB from the display assembly at USB78
2
USB from the right side of keyboard and trackball at USB910
3
USB from the right side of keyboard and trackball zip-tied to the
AUDIO1 header
Touchscreen assembly connections
1.
Refer to Image 2-38 and Image 2-39 for connections and zip-tie locations for the right side of the touchscreen
assembly. These images show the rear of the right side of the touchscreen assembly; this screen is on the
right side, when viewed from the front.