![background image](http://html.mh-extra.com/html/barco/r767302k/r767302k_instructions-manual_474433033.webp)
24-1701050-00 /01
EC-200 to EC-210 Conversion Kit
33
Image 2-38: Touchscreen assembly
—
right-side connections
1
Right-side display DVI (from motherboard)
2
DisplayPort (not connected on the right-side display)
3
USB input (from USB78 on motherboard) to right side (longer cable)
4
USB input (from USB78 on motherboard) to left side (shorter cable
2.
Attach the right-side DVI cable from the motherboard.
3.
Attach the DisplayPort cable from the motherboard to the left-side display.
Note:
The right-side DVI cable and the right-side DisplayPort cable should be routed under the USB
input cable from the USB78 header on the motherboard to the right-side USB interface board. This
should not be a problem, if you route the DVI and DisplayPort cables before you route the USB cable.
Route the left-side video cables along the bottom of the unit in front of the motherboard. Route the
power cable for the right-side display at the same time. These cables can be routed and tie wrapped
to the anchor point located on the bottom of the unit near the center. A 12-volt black and yellow power
cable is already tie wrapped at this location.
You may need to raise or remove the keyboard assembly to route these cables.
4.
Attach the USB input cable from the USB78 header on the motherboard to the right-side USB interface board.
Note:
Two USB cables run from the USB78 header on the motherboard. The longer cable runs to the
right-side USB interface board, and the shorter cable runs to the left-side USB interface board. The
length of each cable determines the USB interface board to which it connects.
Image 2-39: Right-side ties
1
USB input (from USB78 on motherboard) to right side
2
Power to right side
3
USB input cable and power cable zip-tied together to the touchscreen assembly frame
4
USB input cable (from USB78 on the motherboard) to the left-side USB interface board zip-tied to the
touchscreen assembly frame
5.
Route the USB input cable (90409627EF from USB78 on the motherboard) and the power cable to the right-
side USB interface board and zip-tie them together to the touchscreen assembly frame. (See #3 in Image 2-
39.)