6. Menu structure
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 04 - April 2005
_______________________________________________________________________
6-20
6.6.4
Automatic startup
OverView DG
Operation
Identification
Over Temp Protection
Standby timer..
Automatic startup
Lamps
Brightness
Status
On
Off
Figure 6-29
Status menu, Automatic startup
To view or switch on/off the
Automatic startup
, proceed as follows:
•
Use the cursor key to highlight
Automatic startup
.
•
Press
Enter
to select.
The currently selected status is indicated by white dot.
Use the cursor key to highlight the desired status.
Press
Enter
to select.
If
Automatic startup
is
ON
, the projector will immediately be started after being connected to the mains (power
switch switched on).
If
Automatic startup
is
OFF
, the projector will go in
Standby
mode after being connected to the mains (power
switch switched on).
6.6.5
Standby timer
OverView DG
Operation
Identification
Automatic startup
Standby timer..
Error...
Over Temp Protection...
Lamps
Brightness
Installation
Status
Identification
Error...
Over Temp Protection...
Automatic startup
Standby timer..
Figure 6-30
Status menu, Standby timer
If there is no signal, and the standby timer is enabled, a dialog box is displayed and the projector will shut down
after a determined time (power save).
Message
No signal available.
The projector will go to Standby in 300 sec.
Figure 6-31
dialog box warning about the projector switching to standby
