3. Design and functions
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 04 - April 2005
________________________________________________________________________
3-9
3.7
Operation elements
Control Elements
The control elements of OverView D are located on the rear of the system. They include 3 switches and in total 6
LEDs.
Figure 3-6
rear side: control elements
Item
Refers to
Function
1
Power switch
Rocker switch, Power
ON
(up) or
OFF
(down)
2
Standby switch and Power LED
also used for the acknowledge of errors (reset)
3
Active lamp selection switch
Rocker switch,
top: select lamp top, (lamp 1)
bottom: select lamp bottom (lamp 2)
4
Status LEDs
(L1, L2, Fan)
Informs about the operation status of the two lamps and the
fan
5
Lamp door bottom LED
indicates if the lamp door may be opened or not
6
Lamp door top LED
indicates if the lamp door may be opened or not
The operation via the control elements on the rear side (manual user interface) is intended for
servicing purposes only!
The switches and LEDs are described in chapter
Remote-Control
Each OverView D projection module can be controlled by a serial interface or by an IR control unit (IR RCU)
