Barco MUIP-2112, User Manual

Page: 19 / 36

19 K5902132 (451920612534) /03 MUIP-2112
• Do not move the equipment while the power cord and connection cables are connected. Otherwise,
damage to the equipment, power cord and connection cables, fire or an electric shock may result.
Transient over-voltage
To fully disengage the power from the device, please disconnect the power cord from the AC inlet.
Connections
Any external connection with other peripherals must follow the requirements of clause 16 of IEC60601-1 3rd.
Ed. or Table BBB.201 of IEC 60601-1-1 for the medical electrical systems.
To maintain compliance with EMC Regulation, use only shielded interface cables for the connection to
peripheral devices.
Power cords:
• Please use the power cord provided with this equipment. If a power cord is not supplied with this
equipment, please contact your supplier. For all other cases, please use a power cord that matches the AC
voltage of the power outlet and has been approved by and complies with the safety standard of your
particular country.
• Do not overload wall sockets and extension cords as this may result in fire or electric shock.
• Mains lead protection: Power cords should be routed so that they are not likely to be walked upon or
pinched by items placed upon or against them, paying particular attention to cords at plugs and
receptacles.
• The power supply cord should be replaced by the designated operator only, at all time.
Liquids and moisture
Never expose the equipment to liquids or moisture.
Never use the equipment near water - e.g. near a bathtub, washbasin, swimming pool, kitchen sink, laundry
tub or in a wet basement.
The equipment is IPx3 compliant. The power supply is IPx0.
Moisture condensation
Do not use the equipment under rapidly changing temperature and humidity conditions or avoid direct contact
with cold air from air-conditioning outlet.
Moisture may condense on the surface or inside of the equipment, or create a mist residue inside the
protection plate. This is not a malfunction of the product itself, although it may cause damage to the
equipment.
If condensation exists, leave the equipment unplugged until there is no condensation.
Ventilation
When installing the device in a cupboard or another enclosed location, heed the necessary space between the
set and the sides of the cupboard.
The LCD panel becomes warm during operation. This is not a malfunction. Allow adequate air circulation to
reduce the temperature of the equipment.
Installation
• Place the equipment on a flat, solid and stable surface that can support the weight of at least 3 units. If you
use an unstable cart or stand, the equipment may fall, causing serious injury to a child or adult and/or
serious damage to the equipment.
• Do not allow to climb or rest on the equipment.
• When the equipment is attached to an arm, do not use the equipment as a handle or grip in order to move
the equipment. Please refer to the instruction manual of the arm for instructions on how to move the arm
with the equipment.
• Provide full attention to safety during installation, periodic maintenance and examination of this equipment.
• Sufficient expertise is required for installing this equipment, especially to determine the strength of the wall,
arm or ceiling suspension for withstanding the display
’ s weight. Be sure to entrust the attachment of this
Important information