Barco IEX Series, Installation & User Manual

Page: 62 / 80

R5915190 /01 IEX series 62
6.1 Startup Sequence
Startup order
1. Start the distribution box for the LED display.
2. Start the control computer.
3. Start the video processor.
4. Start the sending box.
6.2 Shutdown Sequence
Shutdown order
1. Shut down the video processor.
2. Shut down the sending box.
3. Shut down the control PC.
4. Shut down the distribution box for the LED display.
6.3 Daily Maintenance
Overview
• Check whether ambient temperature and humidity meet the operating conditions for the LED display on a
daily basis.
• Use the LED display and its auxiliary devices at least twice a week and two hours each time. Before using
the LED display, perform warm-up operations if it has been idle for 14 days (for details about warm-up
operations, see
“ Warm-up Operation ” , page 62 ).
• It is recommended that you should use a soft antistatic brush to clear dust on the screen surface monthly in
order to achieve an optimum displaying effect.
• Check the parts in the distribution box quarterly. Check whether the power cables and signal cables for the
LED display are connected securely and safely, and whether the display is grounded reliably.
• Check whether the steel structure is secure on a yearly basis.
6.4 Warm-up Operation
Overview
If the LED display has been idle for 14 days, perform warm-up operations before using the LED display.
Set the pre-stored picture as follows when you initially start the LED display. This setting is for warm-up
operation only. You do not need to set the prestored picture if the LED display is used frequently.
6.5 Warm-up Operation - Setting the Pre-stored
Picture - NovaLCT
How to do
For details about how to set the prestored picture, refer to xxxx.
Select a black background picture. Set Boot Screen to 60 seconds. Set both Cable Disconnect and No DVI
Signal to Prestored Picture . Then click Save to Hardware .
Startup, Shutdown, and Maintenance