3. (Re)placing the RGB input on iCon H600
3. (RE)PLACING THE RGB INPUT ON ICON H600
Upgrade/replacement
The following procedure illustrates the replacement of an RGB input board. The same operations must be done in case one wants
to add a third RGB input to the projector. Instead of removing (the defective) RGB board one has then to remove the board installed
on the desired layer.
Layer 5 is used for the DVI output and cannot be used to install an input board.
Layer 4 is free and can be used to install an extra input.
3.1
Accessing the input section
Overview
•
Removing/installing the cable basket
•
•
•
•
•
•
•
3.1.1
Removing/installing the cable basket
Necessary tools
No tools.
How to remove the cable basket ?
1. Press the button (1) on top of the cable basket to unlock the top part from the projector.
Image 3-1
2. Slightly pull the top of the cable basket forward (2)
3. Pull the cable basket so as to free it from the bottom locks.
How to install the cable basket
This procedure is the reversal of the procedure to remove the cable basket.
1. Position the 2 feet of the cable basket into the 2 bottom locks of the projector.
R5976888 RGB/VIDEO INPUT KIT 30/07/2008
7
Summary of Contents for iCon H600
