Barco FL35, Command Reference Manual

Page: 14 / 24

ECOM Eco Mode GP3, GP4 Get, Set End User 0 - disable, 1 - enable
LPW1
Lamp1 Power GP3, GP4
Get, Set
End User
LPW2 Lamp2 Power GP3, GP4 Get, Set End User
LMOD
Lamp Mode GP3, GP4
Get, Set
End User See value table LMOD
LDLY Lamp Auto Switch Delay GP3, GP4 Get, Set End User
LPW1
LED Power GP3
Get, Set
End User
DBDI LED Power GP3 LED Get, Set End User Use LPW1, this is for legacy
support
LDMM
LED Dim Mode GP3 LED
Get, Set
End User 0 - standard, 1 - custom
LDCR LED Dim Custom Red GP3 LED Get, Set End User
LDCG
LED Dim Custom Green GP3 LED
Get, Set
End User
LDCB LED Dim Custom Blue GP3 LED Get, Set End User
TRG1 Trigger 1 Mode GP3, GP4 Get, Set End User See value table TRGx
TRG2
Trigger 2 Mode GP3, GP4
Get, Set
End User See value table TRGx
TATB Aspect Trigger Behavior GP3, GP4 Get, Set End User See value table TATB See value
table TATB
FLSO
Frame lock Source GP3, GP4
Get, Set
End User 0 - Internal, 1 - External
FLOS Frame lock Output Signal GP3, GP4 Get, Set End User 0 - Off , 1 - Frame lock, 2 -
Pass-through
FLST
Frame lock Status GP3, GP4
Get
End User
Print current frame lock status
TSLR 3D source L/R sync GP3, GP4 Get, Set End User 0 - None, 1 - BNC sync-in
TDLR
3D display L/R sync GP3, GP4
Get, Set
End User 0 - None, 1 - BNC sync-in
TBOS 3D BNC sync-out signal See value table TBOS
FCRE
Factory Reset GP3, GP4
Set
End User
FCRL Factory reset level GP3, GP4 Get, Set Power User 0 - limited, 1 - full
PINC
PIN Code GP3, GP4
Set
End User
Must be executed in standby
CODE Service Code GP3, GP4 Set Power User
RCID
RCID Internal GP3, GP4
Get, Set
End User
DPMS DPMS GP3, GP4 Get, Set End User 0 - disable, 1 - enable
DPMT
DPMS Timeout GP3, GP4
Get, Set
End User
KEYB Backlight Timeout GP3, GP4 Get, Set End User
MNUT Menu Timeout GP3, GP4 Get, Set End User
BACK
Background color GP3, GP4
Get, Set
End User
SPLH Splash GP3, GP4 Get, Set End User
LMUT
LED indicators mute GP3, GP4
Get, Set
End User 0 - off, 1 - on
BAUD Baud rate GP3, GP4 Get, Set End User See value table BAUD
Installation->Trigger
Settings
Installation->Frame lock setup
Installation->LED
Installation->Lamp
3. ASCII Command Sets
601-0381-00_GP3/GP4
Sicilium_1_24
11