Quick Start Guide — Operators
General Procedures
Ensure that the extraction system is on, and the flexible
duct is installed.
If the projector’s
turns red, yellow or blue,
refer to the
section in this guide.
Power Up
Switch on the
. Allow up to one minute for
the projector to finish the boot-up sequence. Boot-up is
complete when the
button turns green.
Remove the lens cap (if applicable).
3
If the lamp is on, press the
button and allow
the lamp to cool for 10 minutes prior to electrical
power down.
After the 10 minute cool down period, switch off the
projector’s
.
Damage will result if you do not
allow the lamp to cool down!
Power Down
2
2
System Reboot Sequence
Switch off the
.
If the lamp is on, press the
button and allow the
lamp to cool for 1 minute.
Continue with normal projector operations as required.
2
After 30 seconds, turn
on, and allow 1 minute
for the system to boot, until
button turns green.
Play the movie from the server.
Check if the
button turns green.
Check if the
button turns green.
Check the image on screen for proper alignment
and color.
: If the image is not aligned with the screen
masking, use the
to correct the
image on screen. Be sure to notify the theater technician.
During normal operations, the server should start the projector automatically.
If it does not start automatically, use the following steps.
Select the appropriate
for the next show.
Allow a moment for the lens to move into position,
and the electronic “masking” files to be loaded.
Play the movie from the server.
Check the image on screen for the proper alignment
and color.
Press the
button. Check if the button
turns green.
Press the
button if required.
Playing a Movie Controlled by the Server
Playing a Movie Manually
Check that the appropriate
is selected.
: If the image is not aligned with the screen
masking, use the
to correct the
image on screen. Be sure to notify the theater technician.
