Barco DP-1500, Installation Manual

Page: 57 / 162

6. Lamp & lamp house
Image 6-10
3. Install the lamp cathode adaptor (A) upon the xenon bulb lamp (L) as illustrated. Use torque 2,5 Nm to fasten the fi xation screw
(S) of the adapter. Use for that a torque wrench with a 5 mm Allen socket. Make sure that there is full contact between the
cathode adapter and the lamp base.
Note: The cathode lamp adaptor is delivered in a separate bag with the projector. In case of a lamp replacement you have to
reuse the adaptor from the xenon bulb lamp which you want to replace.
S
L
A
2,5 Nm
Image 6-11
4. Install the anode wire lug (L) upon the anode socket (S). Hold fast the nut N1 with an open-end wrench while fastening the nut N2
with a torque of 9 Nm using a torque wrench. Ensure that at both sides of the wire lug L a plane washer (W1 & W2) is present.
Note: The anode socket is located just below the UV blocker and can easily be removed from the lamp house. In case of a lamp
replacement you have to reuse the anode socket which is connected to the xenon bulb lamp which you want to replace.
R59770091 DP-1500 06/01/2009 53