BarcoMed C
ORONIS
display controller installation
17
Figure 3: PCI and RAID Controller Slots
Install the BarcoMed C
ORONIS
controller in your computer
following these steps:
1. Turn off the power to your computer and disconnect the
power cord, however make sure that the computer chassis is
still grounded
.
2. Remove the chassis cover according to the manufacturer’s
instructions. Be sure to observe safety warnings.
3. If you have decided to use the on-board VGA capabilities of
the BarcoMed C
ORONIS
(see
Using the VGA capabilities of
the BarcoMed C
ORONIS
on page 16), you
must now remove
any VGA display controller(s) that are currently installed in
the computer or
disable
any VGA controllers that are
integrated into your PC’s motherboard.
4. Install the BarcoMed C
ORONIS
Controller into a free PCI slot,
either 64-bit or 32-bit (see figure 3, for examples of slots).
Be sure that the display controller is seated firmly in the slot.
5. Secure the card to the chassis with the PC’s I/O panel
mounting screw, and replace the chassis cover.
6. Connect the primary display (left most display in a linear
configuration, top most in a vertical configuration) to the
uppermost connector on the BarcoMed C
ORONIS
(the output
farthest from the motherboard –
“Head 1”
in figure 4
Summary of Contents for Coronis 3MP
