Barco Coronis 21-inch Installation & user manua, Installation And User Manual

Page: 55 / 119

Display controller software installation
55
13.
When the driver setup is complete, click the
Finish
button.
The Barco Product Installation Wizard will now guide you through
the installation of MediCal QAWeb, MediCal Pro, or NioWatch,
BarcoMed SelfExam, and the Barco on-line documentation.
14.
When the Setup complete message appears, select
Reboot
System Now
and click
Finish
.
Automated display configuration
Once the drivers, software and documentation have been installed and
your system has been rebooted, the
Barco Monitor Plug and Play
Software
should automatically detect your Barco displays and attach
them to the desktop with the correct resolution. If the
Barco Monitor
Plug and Play Software
fails to detect your Barco displays or fails to
attach them to the desktop correctly please refer to the section,
Setting
the resolution of your C
ORONIS
display
on page 102 in the
Troubleshooting section of this manual.
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any time by
using the Barco Set-up wizard on your Barco system CD-ROM, see
Installing the B
ARCO
M
ED
display controller drivers and software
on
page 53 of this manual.
Uninstalling the drivers and software
To un-install the B
ARCO
M
EDICAL
I
MAGING
D
ISPLAY
S
YSTEM
drivers, software or
documentation, please use the
Windows Add/Remove Programs
utility.
This can be found in the Windows Control Panel.
Note:
If you installed your
B
ARCO
M
EDICAL
I
MAGING
D
ISPLAY
S
YSTEM
drivers with
DualView enabled, the wizard may warn you that DualView must be
disabled before the drivers can be un-installed. This is normal, please
follow the prompts from the wizard.