1. Cooler rigging frame
1. COOLER RIGGING FRAME
1.1
Safety
About this chapter
Read this chapter attentively. It contains important information to prevent damage to the rigging frame. Ensure that you understand
and follow all safety instructions mentioned in this chapter before installing the rigging frame. After this chapter, additional “warnings”
and “cautions” are given depending on the installation procedure. Read and follow these “warnings” and “cautions” as well.
Installation personnel
This assembly of the frame and installation of the cooler must be performed by authorized and quali
fi
ed technical personnel only.
Single assembly only
You can only assemble the rigging frame one single time. While you can remove and install other coolers into the frame. It is not
allowed to disassemble the rigging frame itself.
Expiry date provided adhesive
Make sure to check the expiry date of the adhesive, provided with the rigging frame. Make sure the adhesive (high strength thread-
locker) is not expired.
If expired, makes sure to get new adhesive of similar or higher strength than the one provided in the kit.
Securing all screws and stacking pins
Make sure that the thread of the screws are provided with the necessary amount of adhesive.
C
AUTION
:
Make sure that all the screws are suf
fi
ciently tightened. Respect the torque required to tighten all
screws.
Forgetting or neglecting to do this may result in an unsafe rigging frame.
Transportation of the frame
Never transport the multifunctional frame in portrait position with the coolers mounted. Failure to do so can cause damage the
multifunctional frame.
1.2
Introduction
Functionality
The rigging frame can be used to suspend the coolers from a truss.
Content of the kit
Content
Pieces
Indication
Top frame
1
F1
Bottom frame
1
F2
Vertical pro
fi
le A
2
V1
Vertical pro
fi
le B
2
V2
Rigging screws
8
R
Eye bolts
4
E
Bracket front
1
P1
Bracket left
1
P3
Bracket right
1
P4
Safety plate
1
P2
Screw D912 M8 x 16
12
S
R5906813 COOLER RIGGING FRAME 13/12/2016
1
