R5900085 /03
ClickShare CSE-200+
5
This device radiates heat on its external surfaces during normal operation, which is both normal and safe.
Exposing flammable or combustible materials into close proximity of this device could result in the
spontaneous ignition of that material, resulting in a fire. For this reason, it is absolutely necessary to leave an
“
exclusion zone
”
around all external surfaces of the device where no flammable or combustible materials are
present. The exclusion zone must be not less than 40 cm (16
”
) for all Barco devices. Do not cover the device
with any material while the it is in operation.
Mount the device in a well ventilated area away from sources of ignition and out of direct sun light.
Slots and openings in this equipment are provided for ventilation. To ensure reliable operation of the device
and to protect it from overheating, these openings must not be blocked or covered. The openings should
never be blocked by placing the device too close to walls, or other similar surface. This device should never be
placed near or over a radiator or heat register. This device should not be placed in a built-in installation or
enclosure unless proper ventilation is provided.
In the event of fire, use sand, CO2, or dry powder fire extinguishers; never use water on an electrical fire.
Fusing: Internal fuse for Line is provided in the power supply. A blown internal fuse is an indication of
catastrophic failure of circuit component(s). Repair must be performed by authorized personnel. Fuses must
be replaced with same type and ratings.
1.2 Environmental Condition Check
Environment condition check
For installations in environments where the device is subject to excessive dust, then it is highly advisable and
desirable to have this dust removed prior to it reaching the device clean air supply. Devices or structures to
extract or shield excessive dust well away from the device are a prerequisite; if this is not a feasible solution
then measures to relocate the device to a clean air environment should be considered.
It is the client's responsibility to ensure at all times that the device is protected from the harmful effects of
hostile airborne particles in the environment of the device. The manufacturer reserves the right to refuse repair
if a device has been subject to negligence, abandon or improper use.
Ambient temperature conditions
Max. ambient temperature : +40°C or 104°F at sea level, +35°C or 95°F at 3000m
Min. ambient temperature: 0°C or 32°F
Storage temperature: -10°C to +60°C (14°F to 140°F)
Humidity Conditions
Storage: 0 to 90% relative humidity, non-condensing
Operation: 0 to 85% relative humidity, non-condensing
Environment
The ClickShare product is intended to be used in office and indoor environments only.
Do not install the device in a site near heat sources such as radiators or air ducts, or in a place subject to
direct sunlight, excessive dust or humidity. Be aware that room heat rises to the ceiling; check that
temperature near the installation site is not excessive.
Maximum allowed altitude to use the product : 3000m (9843Ft). Due to China regulation the maximum altitude
is limited to 2000 meter (6561 feet) for China mainland.
1.3 Compliance FCC
Federal Communication Commission Interference Statement
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user's authority to operate the equipment.
