Service Mode
8-12
5976066 BARCOCINE 7 011299
CRT RUN IN CYCLE
A flashing white pattern will be
generated until <EXIT> is pressed.
The projector only uses memory
blocks adjusted on an internal
# pattern; if no such block is
available, the projector can't run
the procedure and leaves the
adjusment mode.
<ENTER> to continue
<EXIT> to cancel
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
MEMORY BANKS
CRT run in cycle
What can be done ?
Only necessary when a new picture tube is installed.
The CRT run in cycle option can only be activated when memory blocks on an internal # pattern are available. When one or more
such blocks are available, a flashing white image (5sec on, 5 sec off) is generated and that for 5 min on the first internal block. In
the next 5 min, a second internal block will be used to generate the flashing white image. The image will also be shifted in a vertical
way to prevent a CRT burn in. To quit the CRT run in cycle option, press EXIT.
How to select CRT run in cycle ?
1.
Push the cursor key
é
or
ê
to highlight 'CRT run in Cycle' (menu 1).
2.
Press ENTER to start up.
If a memory block adjusted on an internal # pattern is available, the CRT run in cycle will start. If no such a block is available,
the projector cannot run the CRT run in option and leaves the adjustment mode.
If you still want to run CRT run in cycle, create first a memory block on an internal # pattern and restart the CRT run in option.
menu 1
menu 2
How to select ?
1.
Push the cursor key
é
or
ê
to highlight 'Common Settings' (menu 1).
2.
Press ENTER to select.
The common settings menu will be displayed (menu 2).
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
MEMORY BANKS
G2 Adjustment
Warning
'G2 adjustment should be performed by BARCO personnel, or BARCO authorized dealers'.
If you are qualified, press
ENTER to continue. If not qualified, press EXIT to return to the Common settings menu. Further description
of the G2 adjustment is given in the Installation manual.
Item is password protected.
When selecting G2 adjustment (menu 1), a safety notice will be displayed on the screen (menu 2).
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
MEMORY BANKS
SAFETY
NOTICE
RISK OF ELECTRICAL SHOCK
IF QUALIFIED, PRESS
<ENTER> TO CONTINUE, OR
IF NOT, <EXIT> TO RETURN.
G2 ADJUSTMENT SHOULD BE
PERFORMED BY BARCO
PERSONNEL, OR BARCO
menu 1
menu 2
menu 1
menu 2
