18
SECTION 4 - CONTROL COMPONENTS
4 - CONTROL COMPONENTS
4.3 MOWER DECK
The cutting deck has a special shape to reduce the power
requirement. The knife is driven directly from the motor
via a belt that is connected to an electromagnetic (EM)
clutch. The knives are activated with a button on the re-
mote control and electronically controlled depending on
the engine status. (see chapter 5.7). The blades used
are a compromise between cutting results and impact
resistance to enable heavier work.
The knives and knife
fastening screws as well as the chains and rubber
guards on the mower deck are SAFETY COMPONEN-
TS and must be checked regularly (see maintenance
program in section 7.2.1.)
The cutting height can be
set directly via the remote control and is indicated by the
display on the right-hand side of the machine (see Figure
8). For maintenance of EM coupling, knives and belts see
chapter 7.2.7.
4.4 ELECTRICAL SYSTEM
The machine is driven electrically. 4 microprocessors
control the functions of the machine to ensure maximum
safety at all times. A motor-driven alternator generates a
voltage of 48 V (Extra Low Voltage - ELV), which is safe
from electrical hazards for people. The caterpillars are
driven by 2 brushless motors that are electronically con-
trolled by 2 inverters that run sophisticated software that
makes the machine easy to use and flexible. The radio
receiver and the fuse and relay box are easily accessible
via the switch cabinet on the back of the machine (Fig. 9).
The electrical system has protection class
IP 54.
4.5 BEACONNET
The machine is equipped with a colored flashing light that
can easily tell the operator the status of the machine: on,
off, alarm, danger, PTO on, power steering, etc.
This simple tool is very effective and convenient for the
operator who receives information simply by watching the
machine in motion. (See Section 5)
Fuse Box
Receiver
Fig. 8
Fig. 9
Summary of Contents for TracMow 95 EVO
Page 6: ...5 NOTES...
