24
SECTION 5 - INSTRUCTIONS FOR A SAFE USE
5 - SAFE USE
5.8 CUTTING HEIGHT ADJUSTMENT
(Fig. 15)
It is possible at any time to control the cutting height from the remote
control. In thick, tall grass, it is recommended that the cutting deck be
set 100mm from the ground to allow the grass to come out. If neces-
sary, perform a second stage with a lower height setting. To raise the
knife, move the control lever (F) up. To lower the mowing deck, move
the control lever (F) down
5.9 AUXILIARY SOCKET
(Fig. 15a)
The machine can be equipped with external devices such as
spray pump, LED lights, rear power lift, etc. This accessory can
be controlled from the remote control. Such a device must be
plugged into the socket (2) and (3) in the rear wall of the engine
compartment (Fig. 15a).
From the left to the right in the Fig. 15-a the socket are:
- Battery 12V stabilized
- 12 V plug controlled by Radio Control (Aux) Fig.10 (C)
- Plug with switching polarity for electric actuator Fig.10 (M)
5.10 CHECKS DURING USE
The electric drive transmission have been design to be maintenance free. Nevertheless
as the machine is equipped by one engine it is necessary to mantein it and to make some
controls everytime you use it. These maintenance operations include safety devices whi-
ch are crucial to assure the safety. Moreover this machine normally works in a inacessible
areas and in case of undesired stop it can be hard to rescue and restore the machine.
Before to start any work, check:
- Anything that was abnormal in the previous operations.
- the level of the Fuel. Replenish it every time
- the level of the oil of the engine: (near to MAX)
- clean the cartridge of the air filter
- the charge of the battery of the remote control
- the condition of the blades (see par.7.1.6), the blade bolts and the protection devices
Oil leakage from mower gear case
- Loosen, broken or lost parts (especially safety shield on mower deck), pins and clips
- deposits of grass and mud on the crawler’s wheels.
- to reduce the fire hazard, and improve the cooling capacity, keep the engine, muffler
(silencer), battery area, and fuel tank area free of debris
- After starting the engine confirm the operation of safety switches
5.11 ACCESS TO AND FROM THE WORK FIELD
Particular attention should be paid to transport and access to the work area. Every loa-
ding, transporting, unloading, crossing of streets, steps, stairs and bridges carries a risk
of its own, to which special attention must be paid.
ON
ON
AUX
Fig. 15 a
Summary of Contents for TracMow 95 EVO
Page 6: ...5 NOTES...
