![Barbeques Galore Turbo TSB10ALP Operator'S Manual Download Page 8](http://html1.mh-extra.com/html/barbeques-galore/turbo-tsb10alp/turbo-tsb10alp_operators-manual_3791055008.webp)
8
Install Tank Holder Brackets and LP Regulator (For TSB10ALP Model)
CAUTION: Build your island before installing the LP Gas Tank and Partition Panel (not included in this unit).
Refer to the heights listed in Fig. 4 on page 9 for constructing your grill island. An island unit is not included
with the purchase of your Side Burner.
3-1
Note: You will need to make 4 holes on your Island Bottom Panel before installing the Tank Holder Brackets.
You will also need to make a hole in your Island Bottom Panel to accommodate your LP Gas Tank. Make
sure the diameter of the hole is at least 9 inches. Make sure the depth of the hole is greater than the
height of the gas tank seat.
Install the Bracket with Regulator onto the Island Side Panel using 2 Phillips Head Screws 3/16"x3/8"
and 2 Flange Nuts 3/16".
Install the Stainless Steel Tube (not included in this unit) onto the Manifold. Next, insert the other end
of the Stainless Steel Tube through the hole on the Island's Side Panel. Install the Stainless Steel Tube
onto the male fitting on the Bracket.
Install the Tank Holder Brackets onto the Island Bottom Panel using 4 Phillips Head Screws 3/16"x3/8".
Tighten 4 Flange Nuts 3/16" onto the ends of the 4 Phillips Head Screws as shown. Be sure that the
flat surfaces of the Tank Holder Brackets are positioned onto the Island Bottom Panel as shown below.
One wing bolt is used to secure the
tank holder.
3-2
Wing Bolt 1/4"x1/2"
Qty. 1 (For LPG model)
Part # S233G04084
(Already installed on the Tank Holder)
Fig. 3
Island Bottom
Panel
B Ring of the
Tank Holder
A Ring of the
Tank Holder
Install the LP Gas Tank (For TSB10ALP Model)
Turn your LP Gas Tank Valve clockwise to the closed or OFF position.
Remove the Wing Bolt from the Right Bracket of the Tank Holder Assembly. Reserve it for later step.
Place the LP Gas Tank into the Tank Holder. Be sure that the bottom of the tank fully rests in the
cutout of the Island Bottom Panel.
Place the reserved Wing Bolt into the Right Bracket of the Tank Holder Assembly to secure the LP
Gas Tank.
Attach the LP Regulator with Hose onto the LP Gas Tank.
Black
Phillips Head Screw 3/16"x3/8"
Qty. 2 (For LPG model)
Part # S112G0306A
Flange Nut 3/16"
Qty. 2 (For LPG model)
Part # S313G0305A
Phillips Head Screw 3/16"x3/8"
Qty. 4 (For LPG model)
Part # S112G03066
Flange Nut 3/16"
Qty. 4 (For LPG model)
Part # S313G03056
Black
Black