15
USE AND CARE INSTRUCTIONS
GRILL INFORMATION CENTER
Call 1-877-934-7455 Monday - Friday 8:00am-4:30pm CST
Troubleshooting
Turn gas off at source and turn Control Knobs to
OFF. W ait at least 5 minutes for gas to clear, then
retry.
If your side burner still fails to light, check gas
supply and connections.
Repeat lighting procedure. If your side burner
still fails to operate, turn the gas off at source,
turn the Control Knobs to OFF, then check the
following:
If the side burner fails to light :
1.
2.
3.
Never
lean over your side burner while lighting or
during cooking. Keep your face and body a safe
distance (at least 18 inches) from the side burner
when lighting your side burner by match.
WARNING
!
!
To purge air from your gas line and/or reset
the regulator excess gas flow device:
Turn Control Knobs to the OFF position.
Turn off the gas at the
source.
Disconnect regulator from LP Gas tank.
For Natural Gas disconnect regulator from
12 ft. Natural Gas Hose.
Let unit stand 5 minutes to allow air to purge
from gas line.
Reconnect regulator to the LP Gas tank.
For Natural Gas reconnect regulator to
12 ft. Natural Gas Hose.
Turn tank valve on SLOWLY 1/4 of a turn.
For Natural Gas open Shut Off valve.
Open the side burner Lid.
Push and turn the Control Knob to HI/ and
press the electric ignitor 3 to 4 seconds to
light the burner.
WARNING
!
Should a FLASHBACK fire occur in or around the
Burners, follow the instructions below. Failure to
comply with these instructions could result in a fire
or explosion that could cause serious bodily injury,
death, or property damage.
!
Shut off gas supply to the gas side burner.
Turn the Control Knobs to OFF position.
Put out any flame with a Class B fire
extinguisher.
Ÿ
Ÿ
Ÿ
Obstruction in gas line
Correction:
Remove regulator hose from side burner.
Do not smoke! Open gas supply for one second to
clear any obstruction from fuel line. Close off gas
supply at source and reconnect fuel line to side burner.
Disconnected Electric Wires
Correction:
Inspect the Electric Ignitor (see Parts List)
found in the Control Box. Connect loose Electric wires
to Junction Box and try to light the side burner.
Weak AA Battery
Correction:
Remove the Ignitor Cap and replace the
battery.
If the side burner still does not light you may need
to purge air from the gas line or reset the regulator
excess gas flow device.
Note:
This procedure
should be done every time a new LP Gas tank
is connected to your side burner.
