background image

LP  Gas  Tank  Installation

10

!

Do  not  store  a  spare  LP-Gas  tank  under  or  near
this  appliance.
Never  fill  the  tank  beyond  80  percent  full;  and
If  the  information  in  "(a)"  and  "(b)"  is  not  followed
exactly,  a  fire  causing  death  or  serious  injury  may
occur.

A.

B.
C.

    WARNING

!

CORRECT  LP  GAS  TANK  USE

Never  connect  an  unregulated  LP  gas  tank  to  your  side
burner.  The  gas  regulator  assembly  supplied  with  your
gas  grill  is  adjusted  to  have  an  outlet  pressure  of  11"
water  column  (W.C.)  for  connection  to  an  LP  gas  tank.
Only  use  the  regulator  and  hose  assembly  supplied  with
your  side  burner.  Replacement  regulators  and  hose
assemblies  must  be  those  specified  by  Grand  Hall.

Have  your  LP  Gas  dealer  check  the  release  valve  after
every  filling  to  ensure  it  remains  free  of  defects.

Always  keep  LP  Gas  tank  in  upright  position.

Do  not subject  the LP Gas tank to excessive  heat.

Never  store  an  LP  Gas  tank  indoors.  If  you  store  your
side  burner  unit  indoors,  always  disconnect  the  LP
Gas  Tank  first  and  store  it  safely  outside.

LP  Gas  tanks  must  be  stored  outdoors  in  a  well-
ventilated  area  and  out  of  the  reach  of  children.

Disconnected  LP  Gas  tanks  must  not  be  stored  in  a
building,  garage  or  any  other  enclosed  area.

The  regulator  and  hose  assembly  can  be  seen  after
opening  the  island's  door  and  must  be  inspected
before  each  use  of  the  side  burner.  If  your  regulator
and  hose  are  damaged  in  any  way,  they  must  be
replaced  prior  to  using  the  side  burner  again.

Any attempt  to  convert  your  side  burner  from  one  fuel type
to  another  is  extremely  hazardous  and  will  void  the
warranty.

Never

  light  your  gas  side  burner  with  the  lid  closed

or  before  checking  to  ensure  the  burners  are  fully
seated  over  the  gas  valve  orifices.

The  LP  Gas  tank  must  be  constructed  and  marked
in  accordance  with  the  Specifications  for  LP-Gas
Cylinders  of  the  U.S.  Department  of  Transportation
(D.O.T.)  or  the  National  Standard  of  Canada,  CAN/
CSA-B339,  Cylinders,  Spheres  and  Tubes  for  Trans-
portation  of  Dangerous  Goods;  and  Commission,  as
applicable.

The  LP  Gas  tank  must  have  a  shutoff  valve,  termi-
nating  in  an  LP  Gas  supply  tank  valve  outlet,  that  is
compatible  with  a Type  1  tank  connection  device.  The
LP  Gas  tank  must  also  have  a  safety  relief  device
that  has  a  direct  connection  with  the  vapor  space  of
the  tank.

The  tank  supply  system  must  be  arranged  for  vapor
withdrawal.

The  LP  Gas  tank  must  have  a  collar  to  protect  the
tank  valve.

!

    WARNING

!

Refer  to  this  table  when  designing  the  island  unit  for  the
TSB10ALP/NG  Model.  Side*  and  Rear*  show  the  mini-
mum  amount  of  distance  the  unit  must  be  from  com-
bustibles  (ex.  Vinyl  or  wood  siding,  fences  and  over-
hangs)  or  sources  of  ignition  (ex.  Pilot  lights  on  water
heaters  and  live  electrical  appliances).  Height*  shows  the
minimum  height  the  island  unit  must  be  starting  from
the  ground  up.

Model

Height

Width

Depth

Side*

Rear* Height*

TSB10A

LP/NG

9"

14"

19-1/2"

36"

36"

29"

Never

  allow  children  to  operate  your  side  burner.  Do  not

allow  children  or  pets  to  play  near  your  side  burner.  Always
supervise  children  and  pets  if  they  are  in  the  vicinity  of  the
unit.
Use  of  alcohol,  prescription  or  non-prescription  drugs  can
impair  your  ability  to  properly  assemble  and  safely  operate
your  side  burner.
Keep  fire  extinguisher  readily  accessible.  In  the  event  of  a
oil/grease  fire,  do  not  attempt  to  extinguish  with  water.  Use
type  B extinguisher or  smother with dirt,  sand or  baking  soda.
In  the event of  rain, turn off the  burners and  gas supply. Wait
for  the  side  burner  to  cool,  and  then  place  a  cover  on  it.
Use  your  side  burner  on  a  level,  stable  surface  in  an  area
clear  of  combustible  materials.
Do  not  leave  side  burner  unattended  when  in  use.
Do  not  move  the  appliance  when  in  use.
Allow  the  side  burner  to  cool  before  moving  or  storing.
Do  not  use  your  side  burner  as  a  heater.
This  side  burner  is  not  intended  to  be  installed  in  or  on
recreational  vehicles  and/or  boats.
The  side  burner  is  not  intended  for  commercial  use.
Never  use  charcoal  or  lighter  fluid  in  this  gas  side  burner.

LP  Gas  side  burner  models  are  designed  for  use  with  a
standard  20  lb.  Liquid  Propane  Gas  (LP  Gas)  tank,  not
included  with  side  burner. 

Never 

connect  your  side  burner

to  an  LP  Gas  tank  that  exceeds  this  capacity.  A  tank  of
approximately  12  inches  in  diameter  by  18-1/2  inches  high
is  the  maximum  size  LP  Gas  tank  to  use. 

You  must  use

an 

"

OPD" gas tank which offers a listed Overfill

 

Prevention

Device.

  This  safety  feature  prevents  the  tank  from  being

overfilled  which  can  cause  a malfunction  of  the  LP  Gas  Tank,
regulator,  and/or  side  burner.

Non-combustible
Construction

6"  minimum  clearance
from  cutout  (for  lid)

Rear*

Side*

Height*

Height

Depth

Wide

Summary of Contents for Turbo TSB10ALP





















Reviews: