Page 3
Assembly Instructions
STEP 1:
Attach the castors
WHAT YOU NEED
2 x Castors with lock (each with M10 nut)
2 x Castors without lock (each with M10 nut)
4 x M10 Flat Washers
4 x M10 Spring Washers
(a) Remove the M10 nuts, then screw the 4 castors onto the underside of the base shelf
(2 castors without lock at the front and 2 castors with lock at the back). Be sure to screw
them all the way in at this stage. They can be adjusted later if the floor is not level.
(b)
Fit 1 M10 Flat Washer and 1 x M10 Spring Washer onto each of the two
rear
castor bolts
from the top of the base panel. Fix each in place with 1 x M10 nut. Tighten the nuts firmly
to lock the castor height.
Attach one “L” bracket to the top of each of the
front
castor bolts
and secure each bolt with 1 x M10 Flat Washer, 1 x M10 Spring Washer, and 1 x M10 nut.
Don't fully tighten yet.
Castor with lock
Castor without lock
Front side has the stainless steel trim.
Castors without lock go at the front.
