Barbeques Galore Grand Turbo B3808ALP, Owner'S Manual

Page: 25 / 52

Assembly Instructions
1. Unscrew Igniter Cap(s) located on the grill Control
Panel and remove the Contact(s) and Spring(s) from
the Battery Holder(s).
2. Place an “ AA ” battery into Battery Holder(s). Be sure
to place the positive pole facing toward you. See
Figure 22.
3. Place the Spring over the AA battery, then place the
Contact on top of the Spring. Screw Igniter Cap(s)
back onto the grill Control Panel.
Electrode Check - Requires an Assistant
Before placing the cooking components into your grill,
ensure that the Spark Electrode Tips are properly positioned
within each Gas Collector Box (a 3-1/4 ” wide stainless
mechanism found at the front between each set of burners).
The easiest way to ensure this is to perform this Electrode
Check:
1. Be sure all Control Knobs are set to ” OFF ” . Open the Grill
Lid.
2. Have an assistant stand behind to the right of the grill and
look down at the Gas Collector Box of the main burners.
NEVER put your face inside Grill Head.
3. Press center Igniter Cap and have assistant watch for a
small blue spark within each Gas Collector Box. if a spark
is present the Electrode Tips are properly positioned.
4. If no spark is seen, the Spark Gap shown in Figure 23
needs to be adjusted as follows:
Using an adjustable wrench, loosen the Inside Nut just
until the Gas Collector Box can be maneuvered and
turned upward.
The gap between the Spark Electrode Tip and Spark
receiver should be approximately 3/16 ” .
If the gap is wider than 3/16 ” use a pair of long nose
pliers and gently squeeze the Gas Collector Box until
the gap is correct.
Return the Gas Collector Box to its original horizontal
position, secure the Inside Nut and try the Electrode
Check again.
lnstalling Cooking Components
Important: Before cooking on your grill for the first time,
wash the cooking grids and warming rack with warm,
soapy water. Rinse and dry thoroughly. Season with cook-
ing oil regularly. After cooking is completed, turn grill to
HIGH setting for about five minutes to burn off excess
grease or food residue.
1. Place the Ceramic Flame Tamers on the Ceramic Rack
and place on the lower ledge above the burners.
3. Evenly space the Stainless Steel Cooking Grids on the
ledge above the Flame Tamers.
4. Place the Upper Warming Rack into the holes on the
upper left and upper right of the back burner frame with
bowl.
BATTERY HOLDER
AA BATTERY CONTACT SPRING
CONTACT
IGNITER
CAP
Figure 22
UPPER
WARMING RACK
COOKING
GRID
CERAMIC
FLAME TAMER
Smoker box
Figure 24
CERAMIC
RACK
2. Place the Smoker Box above Flame Tamers.
Figure 23
GAS COLLECTOR BOX
SPARK ELECTRODE TIP
3/16 ”
SPARK
GAP
Welding
Welding
!
!
!
!
-
24
-
NOTE:There are no Ceramic Tiles above the Infrared Burners.
CAUTION:
Place dust cap on cylinder valve
outlet whenever the cylinder is not in use.Only
install the type of dust cap on the cylinder valve
outlet that is provided with the cylinder valve.
Other types of caps or plugs may result in
leakage of propane.