Barbco TRIBOR 36, Operation Manual

Page: 36 / 47

AUTO RUN
-
The transmitter is ON and Active. Master Thrust and Rotation Brakes are off.
2- Turning on Auto Run- Push the master button on the display. The Auto Run icon will
turn green and the option of Auto Ream will appear next to the Auto Mode button.
3- Selecting Auto Mode- Push the Auto Mode button to select the Auto Ream function.
NOTE- the T Lock and R Lock lights on the remote will illuminate, indicating the auto
functions are active.
4- Verify Set Points- Confirm Pressure limiter set points are adjusted as needed. See
“Pressure Limiters”.
5- Locking in the thrust and rotation-
CAUTION! EQUIPMENT HAZARD
! Always lock in the rotation paddle first.
To avoid burring the cutting head into the formation downhole.
a. Rotate the spindle by pushing the Rotation Paddle in the forward direction until
the desired speed is obtained.
b. Operator will push and hold the R Lock button on the remote. The R Lock LED
will begin to flash. The Rotation paddle is now locked in.
c. Release the R Lock button.
d. Repeat steps a. thru c. for the thrust function.
NOTE - Operator can choose one or both drilling functions to lock in as desired.
NOTE- Stop/ remove rotation lock by moving the rotation paddle. If rotation is stopped
then thrust, if locked in will also stop.
Stop/ remove thrust lock by moving the thrust paddle. Rotation will continue to
operate.
Operation 33